Carrara OBJ Export Settings For Daz Studio 4 Morph Loader Pro
These are the basic settings I use when exporting the obj from Carrara so that it will properly load back into Morph Loader Pro in Daz Studio 4 for Partial Body Morphs. Other settings distorted entire figure instead of just activated the intended morph. Once again, just using this for personal reference and still prefer Carrara over Hexagon mostly cause I haven’t taken the time to learn Hexagon though planning on it.
P.S. I should add that I import to Carrara with default settings.
For the settings to export your primary figures from DAZ to begin your morphing procedures check out this DAZ STUDIO LINK here. I try to keep everything as default as possible unless there is a absolute reason to change it. Hope this is useful for someone as well as my personal future references.
Carrara OBJ Export Settings For Daz Studio 4 Morph Loader Pro
